In nearly all situations, most people spend quite a lot of money buying their forklift. Hence, it is very important to take proper care of it in order to protect your investment well into the long run. It is really a great idea to know the procedures which are carried out in the care and maintenance of this piece of equipment.
By starting up the forklift and listening carefully how it works is among the best ways to tell how good the engine is performing. Like for instance, if there are any misses or knocks, the machine is faulty and this should raise several concerns. Additionally listen carefully for any squealing sounds that come from the belts since these sounds would provide you with a lot of information.
When performing maintenance, several of the main components you will have to pay attention to consist of the safety warning devices, horn, gauges, the overhead guard and the lights. Any burnt out light bulbs or faulty parts need to be replaced as soon as they are noticed. It is also imperative to inspect the wiring.
The battery compartment terminals must be cleaned after the above parts have been checked carefully. If the terminals are not clean, be sure to clean them properly. Every battery cell must be inspected in order to make certain that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machinery and then change the filters. The fuel filters, hydraulic filter and the transmission filter should be replaced on a regular basis. Before fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
When the oil change is finished and the filters have been replaced, a visual inspection of the drive axle has to be done. If there is a grease fitting on the axle make certain to apply some grease. Inspect the engine belts for any frays or cracks. If you find any, fix the issue accordingly. Then, check every other component of the machinery including the wheels. If any kind of issue or fault is detected, be certain to address it immediately so as to make sure the machine is working at its safest and optimum levels.