It is vital to utilize extra care when using a rough terrain scissor lift. Operators must be completely aware of the surrounding environment. Extended booms on the machinery act as levers from the center of the drive unit. For instance, a 6 inch bump can lead to a 3 foot bounce when the operator is at the driver controls. Consider all other traffic in the vicinity, as they might not be aware that you are moving. Plan your assent cautiously. Park the boom lift on a flat surface that has no mud or water. These areas cover deep potholes which can be possibly cause the occupants to fall if the tires fell into the holes. If provided, use all of the outriggers, extended to their full extension position. Be certain to only use wooden chalk blocks which are approved.
Several lifts would operate from the end of the boom on a metal platform. Long booms act levers on the drive unit. While you are at the driver controls, a 6-inch bump could lead to a 3-foot bounce. Be aware of all other traffic. They may not know that you are moving. Plan your assent. Park the boom lift on a flat surface free of any water or mud. These areas can cover deep potholes in which the lift tires could fall, tipping the occupants. Extend all outriggers, if provided, to the full extension position. Place just approved wooden chalk blocks underneath the outrigger pads to prevent the unit from moving.
Overhead power lines are a serious hazard for lift operators regardless of what lift is being used. For example, if the platform operator is not being aware, or if the platform is being controlled by ground personnel that can not correctly access proximity to wiring and hence, either the worker or the platform itself can be easily brought into contact with electrical wires. The employee might be electrocuted unfortunately unless correctly insulated.