Inspect a Forklift
Workplace injuries related to forklift usage within North America average roughly over 10,000 every year, based on the statistics from the HRSDC and OSHA. Some injuries result from the lack of maintenance of the machinery and proper equipment inspection. Other injuries are because of operator error.
Injuries are not the only problems which are related to the operation and maintenance of lift trucks. Another serious concern is damage to property. Lift truck mishaps could cause damage to overhead pipes, sprinklers, and other machines and building walls. By completing thorough inspections on a daily basis, you can help lessen lift truck injuries.
When starting an inspection, turn the engine off. Check the levels of the fuel, engine oil, brake fluid, hydraulic oil and coolant. Visually inspect the machine's tires looking for signs of wear, appropriate air pressure and general condition. Visually inspect the forks on the front of the machine as well. Verify the condition of the top-clip retaining pin and heel. Make sure that the backrest is firmly attached. Make sure that the overhead and finger guards are attached. Visually check the cables and stops, the hydraulic hoses and the mast chains too.
You must check the propane tank if you are utilizing LP or liquid propane forklifts. Check for any indications of corrosion, damage or rust. Be certain that the battery has adequate electrolyte levels and which is charged adequately. Visually check all belts. Check to verify the location of the owner's instruction manual and make certain it is located in the designated on-board storage compartment. Verify the hood latch and make sure that it is operating as it is supposed to. Inspect the seatbelt and make certain it is functioning properly and latches securely.
You can turn the engine on after you have done all the steps mentioned above. Carefully listen to the engine. Investigate any unusual sounds immediately. Make certain that both the parking brake and the service brake are functioning correctly. Confirm that the steering controls and the accelerator are functioning at optimum performance levels.